Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 84)

BIOS
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 84
4.1.12 BIOS Setup Layout
The BIOS Setup default is aligned with the ATCA-7370 BIOS defaults.
4.1.12.1 Board Information Display
The BIOS displays the following board related information in the BIOS setup under "Board Info".
 Current System (label for the loaded BIOS defaults set)
 BIOS version
 BIOS build date
 IPMI Firmware Version
 FPGA Version (On-board FPGA version)
 BIOS Source (boot flash device bank)
4.1.13 USB 2.0 Ports
The ATCA-7370 supports three external 2.0 ports. All USB ports support low-speed, full-speed
and high-speed using the USB 2.0 Enhanced Host Controller Interface (EHCI).
4.1.14 Supported Operating Systems
The ATCA-7370 supports the following operating systems. DOS is used for debugging.
 WRS PNE LE 4.3 Linux and higher
 Red Hat Enterprise Linux 6.x
4.1.15 SPI Boot Flash
The SPI boot flash contains a descriptor mode image with all required parameters as described
in Intel®Patsburg chipset SPI Flash Programming Guide Revision 1.6 (Intel Confidential).