Artesyn COMX-P40x0 ENP2 Installation and Use (January 2015) - Manual (Page 103)

BSP
COMX-P40x0 ENP2 Installation and Use (6806800R95C) 103
4. U-Boot Version
 Run the command "version" after the first line of the U-Boot boot-up message
=> version
U-Boot 2010.06-COMX_P4080_V100R00 (Nov 29 2010 - 16:24:12)
5. JFFS2 rootfs version
 In the U-Boot, boot with nandboot (’run nandboot’). In Linux, run ’cat
/etc/.version
’
[root@COMX-P4080 root]# cat /etc/.version
COMX-P4080 JFFS2 ROOTFS for nand.full FLASH ver:
COMX_P4080_V100R00 build by [email protected] on
Mon Nov 29 08:47:50 UTC 2010
6. NFS rootfs version
 In the U-Boot, boot with nfs (’run nfsboot’). In Linux, run ’cat/etc/.version’.
[root@COMX-P4080 root]# cat /etc/.version
COMX-P4080 NFS ROOTFS ver: COMX_P4080_V100R00 build by
[email protected] on Mon Nov 29 08:50:20 UTC 2010
7.8 CPU
The COMX-P4080 module has the Freescale QorIQ Communications Processor. The CPU
information can be viewed in the terminal. Figure 7-1 below shows console output containing
an example of the CPU information.
Figure 7-1 COMX-P4080 CPU Information