Artesyn MVME51005E SBC Installation and Use (July 2014) - Manual (Page 47)

PPCBug Firmware
MVME51005E Single Board Computer Installation and Use (6806800A38D) 49
Network PReP-Boot Mode Enable [Y/N] = N?
Negate VMEbus SYSFAIL* Always [Y/N] = N?
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Primary SCSI Bus Negotiations Type [A/S/N] = A?
Primary SCSI Data Bus Width [W/N] = N?
Secondary SCSI identifier = 07?
Select the identifier. (Default = 07.)
Y Enable PReP-style network booting (same boot image from a
network interface as from a mass storage device).
N Do not enable PReP-style network booting. (Default)
Y Negate the VMEbus SYSFAIL* signal during board initialization.
N Negate the VMEbus SYSFAIL* signal after successful completion
or entrance into the bug command monitor. (Default)
Y Local SCSI bus is reset on debugger setup.
N Local SCSI bus is not reset on debugger setup. (Default)
Y Asynchronous SCSI bus negotiation. (Default)
S Synchronous SCSI bus negotiation.
N None.
Y Wide SCSI (16-bit bus).
N Narrow SCSI (8-bit bus). (Default)