Artesyn MVME8100 RTM (VXS1-RTM1) Installation and Use (April 2015) - Manual (Page 43)

Controls, LEDs, and Connectors
VXS1-RTM1 Installation and Use (6806800P46C) 43
3.1.2.2.10 RTM eSATA Port 1 and 2 Connector J6
The RTM provides one dual stacked eSATA connector on its front panel. The pin assignment for
this connector is as follows:
4A GIGE1_TRD3_N 4B GIGE2_TRD3_N
5A GIGE1_TRD2_P 5B GIGE2_TRD2_P
6A GIGE1_TRD2_N 6B GIGE2_TRD2_N
7A GIGE1_TRD1_P 7B GIGE2_TRD1_P
8A GIGE1_TRD1_N 8B GIGE2_TRD1_N
9A GIGE1_TRD0_P 9B GIGE2_TRD0_P
10A GIGE1_TRD0_N 10B GIGE2_TRD0_N
D1A GIGE1_LINK1_L D1B GIGE2_LINK1_L
D2A GIGE1_LINK2_L D2B GIGE2_LINK2_L
D3A GIGE1_LED1_PWR D3B GIGE2_LED1_PWR
D4A GIGE1_ACT_L D4B GIGE2_ACT_L
Table 3-11 RTM Dual Ethernet Connector (J5) (continued)
Pin Name Signal Name Pin Name Signal Name
Table 3-12 Dual eSATA Connector (J6)
Pin Name Signal Name
A1 GND
A2 ESATA1_TX_P
A3 ESATA1_TX_N
A4 GND
A5 ESATA1_RX_N
A6 ESATA1_RX_P
A7 GND
B1 GND
B2 ESATA2_TX_P