Artesyn SAM1411 Installation and Use (September 2014) - Manual (Page 73)

U-Boot Commands
SAM1411 Installation and Use (6806800M91B) 73
help print command description/usage
i2c I2C sub-system
i2cinfo Print I2C registers
iminfo Print header information for application image
imls List all images found in flash
imxtract Extract a part of a multi-image
iopinfo Print I/O Port registers
iopset Set I/O Port registers
itest Return true/false on integer compare
loadb load binary file over serial line (kermit mode)
loads Load S-Record file over serial line
loady Load binary file over serial line (ymodem mode)
loop Infinite loop on address range
ls list files in a directory (default /)
mccinfo Print MCC registers
md Memory display
memcinfo Print Memory Controller registers
mii Mii utility commands
mm Memory modify (auto-incrementing)
mmc MMC sub system
mmc_spi mmc_spi setup
mmcinfo mmcinfo <dev num>-- display MMC info
mtdparts define flash/nand partitions
mtest Simple RAM read/write test
muxinfo Print CPM Multiplexing registers
mw Memory write (fill)
next single step execution, stepping over subroutines
Table 7-1 U-Boot Commands (continued)
Command Description