Avery Dennison SS Finisher - Manual (Page 12)

Users Manual SS Finisher Operation •••• 12
IMPORTANT: FOR PROPER OPERATION, USE THE FACTORY
SETTINGS AT ALL TIMES. CHANGING THESE SETTINGS MAY
RENDER THE SONIC KNIFE INOPERABLE, REDUCE THE
QUALITY OF THE CUT AND/OR REDUCE THE RELIABILITY
OF THE SONIC KNIFE.
Settings
The Power Supply is set properly at the factory. Any changes to the factory
setting may result in improper operation. If necessary, the factory settings may
be restored as follows:
AUTO/MAN switch AUTO
CUTTING CONTROL 0
US-TIME 0
37 PIN CONNECTOR
CABLE
COAXIAL CONVERTER
AC POWER CABLE
Test Button
The "Test" button can be used to check the operation of the sonic stack
assembly. This is done by depressing the switch while observing the power
indicator. If more than 2 bars are illuminated, the stack requires repair.
AUTO/MAN Switch
The AUTO/MAN switch should always be in the AUTO position.
CUTTING-CONTROL and US-TIME Controls
The CUTTING-CONTROL and US-TIME Controls should always be set to 0.