Avery Dennison SS Finisher - Manual (Page 37)

Users Manual SS Finisher Appendix D •••• 37
Appendix D
Multi Color Contrast Sensor Installation Instructions
Sensor Installation - Option No. 420014
1. Disconnect sensor cable from existing sensor.
2. Cut sensor cable tie holding the sensor cable to the tie holder attached to the
frame.
3. Remove existing sensor mount bracket. Retain the mounting hardware. (2
#8-32 SHCS and 2 # 8 flat washers)
4. Fasten Item 5 (Bracket, Sensor Mtg.) to the frame using the saved hardware.
5. Assemble Items 1, 2, 3 and 4 (Sensor, Bracket Guide, Sensor Slide and #10
Screws Respectively) as shown in the attached catalog pages.
6. Align Item 3 (Sensor Slide) with slot in Item 5 (Bracket, Sensor Mtg.) and
install Items 6, 7 and 8 (#10 Flat Washer, #10 SHCS x 3/8” and Thumbscrew
Knob).
7. Replace existing cable with new cable (421142 supplied). Replace all cable
ties.
8. Connect the sensor cable to the Sensor. Position the sensor to its farthest
position.
9. Cable tie sensor cable to the tie holder attached to the frame