Baby Lock Cover Stitch (BLCS-2) Instruction and Reference Guide - Manual (Page 11)

O
V
E
R
V
I
E
W
9
Setting Up Your Baby Lock (Cont.)
5. Position the telescopic thread guide.
Raise the telescopic thread guide to its high­
est position. Rotate the shaft to the left and
right until each section "clicks" into a locked
position (fig. B).
6. Opening Front table
To open the front table, place your thumb
against the tab, and slide the cover to the
right. A slight pull toward you will allow the
cover to swing down, providing access to
the chain looper.
(fig. C).
Side Cover
Open side door on the left for easy access to
the chain looper thread tray.
Close door before sewing.
B
C
★New_BLCS-2 Ta:BLCS-2 En.qxd 2009/05/25 16:58 ページ 9