Baby Lock Cover Stitch (BLCS-2) Instruction and Reference Guide - Manual (Page 24)

C
O
V
E
R
S
T
I
T
C
H
22
The narrow cover stitch consists of two rows of straight stitching on the top side of the fabric with the
overlock stitch on the underside of the fabric. This stitch is very common in the garment industry to hem
knit garments. The narrow cover stitch is used on fine knits such as jersey and single knits for hemming
or topstitching. The cover stitch is not limited to knit fabrics. It also works well with woven fabrics.
The Left Narrow cover stitch is formed using two "C" needle positions and the chain looper. The needle
positions are C­1 and C­2. The width of the narrow cover stitch is 3mm.
For Cover Stitch:
1. Place the machine in locked position to thread the chain looper. (pg.13)
2. Follow the diagram to thread the chain looper, (pg. 23). Open the side cover of the machine to make
sure the thread is through the eye of the looper. Trim the thread to 4 inches (10cm) and lay in tray.
3. Follow the diagram to thread the chain/cover stitch needle positions C­1 and C­2. Place needle
threads on top and to the left of presser foot before sewing.
4. Move the lock button release lever to the right.
5. Set stitch length and other machine adjustments.(See chart below)
6. Place the fabric under the needles and turn handwheel toward you two or three stitches into the
fabric. Cut the excess threads and start sewing.
Note: All chain and cover stitches must be started with fabric under the needle.
COVER STITCH - LEFT NARROW
Cover Stitch ­Left Narrow ­ 3mm
Needle Position
C­1 and C­2
Stitch Length
3,0 ­ 4,0
★New_BLCS-2 Ta:BLCS-2 En.qxd 2009/05/25 16:58 ページ 22