Baby Lock Cover Stitch (BLCS-2) Instruction and Reference Guide - Manual (Page 16)

T
H
R
E
A
D
I
N
G
14
Chain Looper
1. With the presser foot up and machine lock button in the locked position, (fig. A pg. 13).
2. Place the thread cone or spool on the "Chain Looper" spool pin. Slip the thread into the telescop­
ic antenna thread guide above the thread cone.
3. Insert the thread through the hole of the thread guide above the chain looper tension dial. Bring
the thread under the chain looper tension dial, then up and over the left thread guide,making sure
the thread is in the tension disk. (fig.A).
4. Take the thread down to the chain looper threading port.
5. Pull 18 inches (40cm) of thread and insert 1 inch (10cm) of thread into the chain looper threading
port. Use tweezers if necessary, to insert the thread end. (fig. B).
6. Depress the looper threading lever. (fig. B). If the thread does not go through the chain looper eye
with one push, depress the threading lever again until it does.
7. Open side cover to the left for easy access to the chain looper thread in tray (fig. C).
8. Trim excess thread to 4 inches (2.5cm) from the eye of chain looper and leave it hang.
9. Close side cover.
10. Move the lock button release lever to the right.
A B
C
★New_BLCS-2 Ta:BLCS-2 En.qxd 2009/05/25 16:58 ページ 14