Baumatic BHI909TS.GWK - Manual (Page 30)

This appliance is classified as Class 3 and therefore is to be built into a
kitchen unit (depending on size) or 600 mm worktop that is between
30 mm and 40 mm thick. The following minimum clearance distances
must be observed:-
o
The rear edge of the hob must be a minimum distance of 50 mm
from the rear wall.
o
If the hob is positioned so that the right
or left hand side of the appliance will be
near to the edge of a kitchen unit. There
must be a gap of at least 100 mm
between the side of the hob and the
vertical surface of any kitchen unit that
is made of a combustible material. If the vertical surface is made of
a non-combustible material, then 50 mm clearance is sufficient.
HOWEVER sufficient space must be allowed for saucepan handles
to be turned and for saucepans to be used safely.
o
900 mm between the highest point of the hob surface (including the
burner) and the underside of any horizontal surface directly above
it.
o
400 mm between the hob surface, providing that the underside of
the horizontal surface is in line with the outer edges of the hob. If
the underside of the horizontal surface is lower than 400 mm, then
it must be at least 50 mm away from the outer edges of the hob.
o
50 mm clearance around the appliance and between the hob
surface and any combustible materials.
o
IMPORTANT: Underneath the appliance there must be a
partition made of insulating material (e.g. wood). There must be
a gap of at least 20 mm between the underneath of the
appliance and this partition.
30