Beurer BC 58 - Manual (Page 21)

21
NOTICE:
• If this monitor is stored near the freezer, allow it to ac-
climate to room temperature before use.
• Avoid high temperature and solarization.
• Changes or modifications to the device will nullify the
user warranty.
• Do not drop or insert any object into any opening. This
may damage the unit.
• Do not press the buttons with excessive force or with
pointed objects.
To keep your digital blood pressure monitor in the best con-
dition and protect the unit from damage follow the direc-
tions listed below:
• Clean your device and cuff carefully only with a slightly
moistened soft cloth and dry it immediately with a soft
dry cloth. Do not press.
• When storing the device, make sure that no heavy ob-
jects are placed on top of it.
• If the unit is stored near freezing, allow it to acclimate
to room temperature before use.
• Always store the unit in the box after use.
• It is recommended the cuff should be disinfected
2 times every week if needed (for example, in hospital
or in clinique). Wipe the inner side (the side contacts
skin) of the cuff by a soft cloth squeezed after moist-
ened with Ethyl alcohol (75 – 90 %), then dry the cuff by
airing.
• This unit may not meet its performance specifications if
stored or used outside of the temperature and humidity
ranges (see section “12. Technical Specifications”).
• Use the unit consistent with the instruction provided in
this manual.
10. Alarm / error messages /
troubleshooting
The monitor will show Ki or Lo as technical alarm on LCD
with no delay if the determined blood pressure (systolic or
diastolic) is outside the rated range specified in part “Tech-
nical Specifications”. In this case, you should consult a phy-
sician or check if your operation violated the instructions.
The technical alarm condition (outside the rated range) is
preset in the factory and cannot be adjusted or inactivated.
This alarm condition is assigned as low priority according
to IEC 60601-1-8.
The technical alarm is non-latching and need no reset. The
signal displayed on LCD will disappear automatically after
about 8 seconds.