Beurer BM 90 - Manual (Page 20)

20
• When switched off, press the seT button for approx. three seconds. The year display will start to flash. Set
the year with the MeM button and confirm with the seT button.
• Then set the month, day, time format (24h/12h), hour, minutes and measurement unit (mmHg/kPa) and confirm
each setting with the seT button.
• After you have performed all the settings, appears on the display and the device automatically switches
off.
Operating the blood pressure monitor with a mains part
You can also operate this blood pressure monitor with a mains part. When doing so, there must not be any bat-
teries in the battery compartment. The mains part can be obtained from specialist retailers or from the service
address using order number 071.50.
• To prevent possible damage to the device, the blood pressure monitor must only be used with the mains part
described here.
• Insert the mains part into the connection provided for this purpose on the right-hand side of the blood pressure
monitor.
The mains part must only be connected to the mains voltage that is specified on the type plate.
• Then insert the mains plug of the mains part into the mains socket.
• After using the blood pressure monitor, unplug the mains part from the mains socket first and then disconnect
it from the blood pressure monitor. As soon as you unplug the mains part, the blood pressure monitor loses the
date and time setting but the saved measurements are retained.
6. Measuring blood pressure
Ensure the device is at room temperature before measuring.
Attach the cuff
The unit may only be operated with the original cuff. The cuff is for an arm circumference of 22 to 42 cm.
Adopt the correct posture
• Before every measurement, relax for about five minutes. Otherwise deviations can occur.
• You can perform the measurement while sitting or lying. Make sure that the the cuff is at heart level.