Beurer GL 40 (mmoL) - Manual (Page 27)

Beurer GL40 mmol/L 27
6 The Measured Value Memory
Your blood sugar level is automatically stored with every measurement, unless "CtL" was
activated during a blood sugar measurement with control solution.
The measured value memory can store up to a maximum of 480 values. Once this num-
ber is reached, the measured value always replaces the oldest value in the memory. You
can retrieve each individual blood sugar measured value. For the blood sugar levels, you
can calculate and display the average value for the last 7, 14, 30 and 90 days.
Note
• If measured values are already stored in the memory and you then reset the date, the
average values are calculated according to the new time period.
• "---" indicates that the measured value memory is empty. Press the ON/OFF button to
switch off the unit.
6.1 Displaying individual values
The individual values of the last 480 measurements are displayed. The most recent value
is displayed first, and the oldest value is displayed last. The measuring device also dis-
plays the date and time of the measurement.
1 The measuring device must be switched off. Press the S or T rocker button [5].
2 The start display appears briefly.
"MEM" and the number of stored blood sugar tests are displayed briefly (Fig. 1). Then
the stored value is displayed with the measuring unit, date, time and "MEM" (Fig. 2).
Fig. 1 Fig. 2
3 Every time you press the T rocker button [5] again, the memory position number ap-
pears followed by the previous measured value. You can display a maximum of 480
previous measured values.
4 You can cancel the process at any time. To do so, press the ON/OFF button or wait
until the unit switches off automatically after 1 minute.