Blackstar HT-DELAY - Manual (Page 5)

e. To playback your recorded phrase, press the Loop switch.
Holding the Loop switch down will loop the phrase, alternatively
pressing the Loop switch at anytime will retrigger the phrase
for a sampling effect.
f. At any time pressing the Effect On/Off switch will turn the
sampled phrase on or off.
Loop 2 Mode – Sound on sound delay looper
In this mode you can overdub a new sound on to the recorded
sound as many times as you want.
How to use Loop 2
a. When Loop 2 is selected, the Loop LED blinks slowly RED.
b. Pressing the Loop switch puts the pedal into RECORD READY
mode and the Loop LED flashes quickly RED.
c. Recording starts automatically as soon as you start to play the
guitar and the Loop LED is lit solid RED.
d. Pressing the LOOP switch will complete the recording and the
pedal goes into PLAYBACK mode automatically and the LED is
lit solid GREEN.
e. In this mode, when the LED is GREEN, you can play along with
the looping sound.
f. When you press the Loop switch again, the Loop LED lights
ORANGE to show you are in OVERDUBBING mode. As you
play the new phrase it is overdubbed onto the existing recorded
sound.
g. Pressing the Loop switch again will complete the overdub. The
LED will return back to GREEN and you are back in PLAYBACK
mode.
h. By repeating steps (f) and (g), you can overdub the looping
sound as many times as you want .
Note: Loop time is determined by the length of the first recorded
phrase.
English
10
11. Effect On/Off LED
When the RED LED is on the effect is present. When the RED
LED is off the pedal is in bypass.
12. Effect On/Off Footswitch
Press this switch to turn the effect on or off.
13. Tap / Loop LED
In Linear, Analogue, Multihead 1, Multihead 2, Tape and Space
modes this LED blinks at the current delay time. The most recent
change either by the Tap switch or Time knob sets the delay time.
In Loop mode this LED indicates the loop status as described in
Loop 1 and Loop 2 Mode sections below.
14. Tap / Loop Footswitch
In Linear, Analogue, Multihead 1, Multihead 2, Tape and Space
modes pressing the Tap switch more than 2 times with the same
intervals will adjust the delay time.
Loop 1 Mode – One shot / Loop playback
This mode allows for a phrase of up to 7.2 seconds to be
recorded and played back at any time during a performance. The
Loop footswitch can be used to retrigger the phrase for a
sampling effect.
How to use Loop 1
a. When Loop 1 is selected, the Loop LED will blink slowly RED.
b. Pressing the Loop switch puts the pedal into RECORD READY
mode and the Loop LED flashes quickly RED.
c. Recording starts automatically as soon as you start to play the
guitar and the LOOP LED lights solid RED.
d. To finish recording press the Loop switch and the Loop LED will
turn to solid GREEN (if the recorded phrase lasts more than
7.2sec, the recording will stop automatically when that time is
reached).
English
9