Bolide SVR9000DMOB_W - Manual (Page 27)

User Manual
23
Alarm Type Function
Video Loss
Sends alarm when DVR can’t receive video signal (such as camera damage, cable broken or
damaged or power supply malfunction).
Motion Detection
When an object moves into motion detection area, alarm will be triggered. You can adjust sensitivity
level to suit the needs of your actual application environment.
I/O Status System can convert alarm signal triggered by external sensor into signal identified by system.
HDD loss
When Hard Drive is not detected (HDD damage, power supply malfunction), or HDD auto-overwrite is
off, and free space is not enough, an alarm will be triggered.
5.3.6 Device
5.3.6.1 HDD Set
Click [Main menu
ÆDeviceÆHDD] to enter into the interface shown as Picture 5-35.
When DVR is connected to a HDD, the system will automatically detect if HDD is normal or not;
If the cable connected to HDD is loosen or HDD is abnormal, HDD status will be shown as “No Disk”,
or, If HDD need to be formatted, status will be shown as “no format”, otherwise, the HDD status will be
shown as “Normal”
¾ NO: indicate HDD no pre-seted by system.
¾ Status:˖It will be available only when HDD have been formatted.
¾ Total Space – Total size of the hard drive currently installed.
¾ Free Space – Total amount of free space available on the hard drive currently installed.
¾ Useable Rec. Time – Free space currently available in hours.
¾ Auto-overwrite – When set to ENABLE the DVR will record over the oldest files on the hard drive.
The DVR will always be able to record events as they happen, however, it does means that you’ll need to
get important events off the HDD before they’re overwritten; and if overwrite is set to DISABLE the DVR
will stop record once the DVR is full. Whilst you won’t lose old footage, you run the risk of missing new
events as they happen. Be sure you want to do this before selecting it.
¾ HDD Alarm: If you select <Restart>, that means system will auto restart two minutes later after
power on when HDD can’t be found or formatted, also user can select <Ignore> to cancel this <Restart>
function.
¾ HDD Format – Formatting the HDD will erase all data (i.e. footage) which is stored on it, and
re-create the FAT (file allocation table).
List 5-1
Picture 5-35 Picture 5-36