2 ptz setting – Bolide SVR9000DMOB_W User Manual

Page 28

Advertising
background image

User Manual

24

¾ USB Format - If you have a USB flash drive connected to the DVR, you can format that, too. To do
this, click the [USB Format] button and click [OK].

Note: It is an important first step when configuring your DVR to make sure that the hard drive (HDD)

options are correctly set. So, strongly suggest that you do format the HDD before start the first record.

5.2.6.2 PTZ Setting

Click [Main Menu

ÆDeviceÆPTZ] to enter into the below window shown as Picture 5-37.

5.3.6.3



Vehicle Setup



Enter into [Main menu

ÆDeviceÆ Vehicle] to enter into the interface shown as Picture 5-38.

Note: When starting speed test via Sensor, please connect green wire (Speed) to speed sensor.

You could select the channel you desire to control and

set PTZ protocol (Pelco-D or Pelco-P), Baud Rate (1200,

2400, 4800, 9600), Data bit (8, 7, 6, 5), Stop bit (1, 2), Parity

Check (None, Odd, Even, Mark, Space), Address Code and

Cruise status respectively. Please note the PTZ device can

be activated only when a channel in connection with the PTZ

camera is selected.

¾ Record LP: allows you configure if the license plate number

display on the recorded data or not.

¾ Preview LP: allows you set if the license plate number appear

on Live screen or not.

¾ Record GPS: allows you add GPS information to video data.
¾ Speed Resource: achieved by GPS signal or sensor speed

detection signal.

¾ License Plate: you can configure the car license plate here

and the model supports the plate with Chinese character.

¾ Delay power off: you can configure how long DVR is

delayed power off after car ignition is off. Options include

<off, 1min, 5min, 10min, 20min, 30min, 40min, 50 min and

60min>

¾ Speed Setting: Enter into speed setting interface shown as

Picture 5-40.

z Click [Start speed test] button while car start moving.
z Click [Stop] button when car dial plate shown one

kilometer

z Now you can find the pulse count per one km shown as

Picture 5-40, click [Save] button to exit the interface.

Picture 5-37

Picture 5-38

Picture 5-39

Advertising