BrightSign Network WebUI User Guide v.3.9 User Manual
Page 30
26
Note: Since there is often a delay between changes
to groups/players in the WebUI and the corresponding
player updates, the target status and reported status
will sometimes be different.
•
Firmware: The current firmware version installed
on the player
•
Autorun ver. (standard): The current autorun
version of the BrightAuthor presentation assigned
to the player.
•
Autorun ver. (custom): The current autorun
version of the custom-built presentation assigned
to the player. Visit this
to learn how to
distribute custom autorun scripts using the
BrightSign Network.
•
IP address: The IP address of the player
•
Card Size: The total capacity of the SD card
installed in the player
•
Subscription type: The type of BrightSign
Network subscription assigned to the player
•
Subscription status: The current status of the
BrightSign Network subscription assigned to the
player
•
Delete: Removes the player from the BrightSign
Network.
The
Advanced tab provides the following functionality:
•
Unit Control: This section allows you to send
commands to a player:
a. Reboot Unit: Check this box to have the player
reboot the next time it checks in to the
BrightSign Network.
b. Upload Logs: Check this box to have the player
upload its logs to the BrightSign Network the
next time it checks in.
c. Recovery – reformat: Check this box to place
the player in recovery mode. The player will also
reformat its storage card.