BSS Audio DPR-901II Owner's Manual - Manual (Page 7)

7
Mains Power
The internal power supply regulators are mounted on the case sides
and use this as their heatsink. After a period of time in an enclosure,
the metal case will feel hot to the touch, but this is quite normal and
should not be a cause for alarm.
Before connecting your unit to its AC power source, check that the
voltage selector switch located on the rear panel is correctly set.
See figure 2.2.
WARNING: THIS APPLIANCE MUST BE EARTHED.
IMPORTANT: The wires in this mains lead are colour coded in ac-
cordance with the following code:
Green and yellow......Earth
Blue......Neutral
Brown......Live
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to
the terminal in the plug which is marked with the letter 'E' or by the
earth symbol , or coloured green and yellow.
The wire which is coloured blue must be connected to the terminal
which is marked with the letter 'N' or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter 'L' or coloured red.
Those units that are supplied to the North American market will have an
integral moulded 3 pin connector which is provided to satisfy the area
safety standards.
Fig. 2.2 Mains Voltage
Switch and Fuse
2.3 Mains Power
FOR CONTINUED PROTECTION AGAINST FIRE
REPLACE ONLY WITH THE SAME TYPE OF FUSE
SELECT VOLTAGE
AC 50/60Hz 40 WATTS MAINS POWER T250mA 230V
T315mA 115V
MAINS SUPPLY
ON DESIGNED & MANUFACTURED BY BSS AUDIO Ltd. ENGLAND