BSS Audio Prosys PS-8810 Owner's Manual - Manual (Page 62)

- 62 -
PS-8810
DIGITAL SIGNAL PROCESSOR
The Auto-leveler works in tandem with the Input Gate to
compensate for long-term average input levels that vary over
time. When the Auto-leveler is enabled, the open state gain of the
corresponding Input Gate, normally 0dB, is adjusted dynamically
to achieve a desired average output level. The Auto-Leveller’s
affect on input gain is metered by the Input Dynamic Cut/Boost
Meter.
In the example above, the Threshold is set to –20db and the
autoleveller allows the input signal to pass unaffected at levels
below the Threshold. At input signals above the Threshold, the
autoleveller adds gain to try and adjust the signal to the 0db Target
Level. At input signal levels above 0db, the signal is clamped to
0db.
Eight parameters control this feature:
On/Off
Turns this feature on or off
Processing Functions Auto-leveler
b
c
d
e
f
g
h
i
1
Auto-Leveler