Caple C621 - Manual (Page 12)

Page 12
C621 C721 user manual.DOC
FASTENING THE COOKTOP
Each cooker top is provided with an installation kit including brackets and screws for
fastening the top to fixture panels from 20-30 to 40 mm thick, figs. 6.11 (2 electrical plates
hob.
• Cut the unit.
• Stretch gasket "D" over the edge of the hole made, being careful to overlay the junction
edges
• Turn the cook top over and put tabs "A" (fig. 6.10) into the mountings, only tighten
screws "B" a few turns. Make sure that the tabs are mounted correctly as shown in the
figures 6.11 and 6.12. Turn the tabs so that the cook top can be put into the hole.
• Put the cook top into the hole cut into the unit and position it correctly.
• Put tabs "A"; into place, tooth "C" of the tabs should go into the hole.
• Tighten screws "B" until the cook top is completely secured.
• Using a sharp tool cut off the part of gasket "D" which protrudes from the cook top.
GAS CONNECTIONS
Make sure that the hob is adapted to function with the type of
gas supply available (see label). If not, refer to the section
headed "Adapting the appliance to function with different types of
gas".
GASES
The gases used for the operation of cooking appliances may be
grouped by their characteristics into two types:
• Liquid gas: Butane gas (G 30) and Propane gas (G 31)
• Natural gas (G 20)