Caple C621 - Manual (Page 9)

Page 9
C621 C721 user manual.DOC
INSTALLATION ADVICE
IMPORTANT
• The appliance should be installed, regulated and adapted to function with
other types of gas by a QUALIFIED INSTALLATION TECHNICIAN.
• Failure to comply with this condition will render the guarantee invalid.
• The appliance must be installed in compliance with regulations in force.
• Installation technicians must comply to current laws in force concerning
ventilation and the evacuation of exhaust gases.
• Always unplug the appliance before carrying out any maintenance operations
or repairs
• The appliance must be housed in heat-resistant units.
• These tops are designed to be embedded into kitchen fixtures measuring 600
mm in depth.
• The walls of the units must not be higher than worktop and must be capable
of resisting temperatures of 75 °C above room temperature..
• Do not install the appliance near inflammable materials (e.g., curtains).
GAS HOBS
TECHNICAL INFORMATION FOR THE INSTALLER
Before installing the cook top, remove the protective film.
This cook top can be built into a working surface 20 to 40
mm thick and 600 mm deep.
In order to install the cooker top into the kitchen fixture, a
hole with the dimensions shown in figs. 6.1 a - 6.1 b has to be made, keeping in
consideration the following:
• Within the fixture, between the bottom side of the cooker top and the upper surface of
any other appliance or internal shelf there must be a clearance of at least 30 mm;
• The cooker top must be kept no less than 100 mm away from any side wall;
• The cooker top must be kept at a distance of no less than 50 mm from the rear wall.
• There must be a distance of at least 650 mm between the hob and any wall cupboard or
extractor hood positioned immediately above (see fig. 6.2)
• The coatings of the walls of the unit or appliances near the cook top must be heat
resistant ("Y" protection against heating in compliance with standards EN 60335-2-6).
Do not install the appliance near inflammable materials (e.g.. curtains).