Caple C621 User Manual
Page 16
Page 16
C621 C721 user manual.DOC
• The power supply cord must not touch against any hot surfaces and must be placed so
that it’s temperature does not exceed 75°C at any point along it’s length.
• After having installed the appliance, the power switch or power plug must always be in a
accessible position.
• The appliance must have its own supply; any other appliances installed near it must be
supplied separately.
N.B. For connections to the mains power supply, never use adaptors, reductions
or multiple power points as these may overheat and catch fire.
In the event that installation should require modifications to the mains supply wiring system,
it is recommended that a qualified technician be called to carry out substitution.
The technician will also have to verify that the cross-section of the electric cables on the
power point match the appliance's power rating.
A double pole switch must be provided no further than 2 metres from the appliance to the
electrical supply.
If you are using the hob for the first time, or after a period of disuse, you should set the
controls to position 1 for approximately 30 seconds, to dry out any humidity.
This appliance must be connected by a competent person,
using fixed wiring via a DOUBLE POLE SWITCHED
FUSED SPUR OUTLET.
We recommend that the appliance is connected by a
qualified electrician, who is a member of the N.I.C.E I C.
and who will comply with the I.E.E. and local regulations.
The wires in the mains lead are coloured in accordance
with the following code: -
Green & Yellow =
Earth
Blue
=
Neutral
Brown
=
Live
As the colours of the wires in the mains lead for the appliance, may not correspond with the
coloured markings identifying the terminals in your spur box, proceed as follows:
1. The wire which is coloured green and yellow must be connected to the terminal
marked E (Earth) or coloured Green.
2. The wire which is coloured blue must be connected to the terminal marked N
(Neutral), or coloured Black.
3. The wire which is coloured brown must be connected to the terminal marked L
(Live), or coloured Red.
Before carrying out any work on the electrical section of the appliance, it must be
disconnected from the mains.
Connection to a good earth wiring system is absolutely essential.
The manufacturer accepts no responsibility for any inconvenience caused by
failure to comply with this rule.