Desa E36L - Manual (Page 11)

www.desatech.com 111076-01F 11
ACCESSORy INSTALLATION
Continued
6. Slide blower mount towards rear of firebox
until locking tabs line up with notched
openings and lower mount down and
away (see Figure 18).
7. Remove blower/heater assembly with 4
screws from packaging. Blower is pre-
wired for convenience.
8. Align blower assembly over hole pattern on
blower mount and attach with 4 pan head
screws provided (see Figures 19 and 20).
9. With discharge pointing towards you, guide
assembled blower mount into fireplace
and center rear mounting flanges between
standoff brackets at rear of the fireplace.
10. Lift blower mount up and position 4 locking
tabs through notched openings in firebox
top. Slide assembly forward until locked
into position.
11. Remove control panel knockout plug lo-
cated in heater switch position by pressing
locking tabs and pushing plug out through
front of panel (see Figure 21).
12. Firmly insert red power switch into open
mount location with “ON” (I) indicator
positioned on top.
Figure 18 - Disassembling Blower Mount
Control
Panel
Control
Cover
Blower
Mount
Control
Cover
Screws
Hex.
Screws
Notches for Control Cover
Blower Mount
Notch (1 of 4)
Screws
Figure 19 - Mounting Heater/Blower
Figure 20 - Mounting Alternate Heater/
Blower
Harness
Strap
Heater/
Blower
Assembly
Blower
Mount
Mounting
Screws
Mounting
Screws
Heater/
Blower
Assembly
Blower
Mount
Figure 21 - Installing Heater Power Switch
Knockout Plug
Remove to
Install Power
Switch
Power
Switch