Desa E36L - Manual (Page 18)

www.desatech.com 111076-01F 18
ACCESSING IMAGING UNIT
Imaging unit can be accessed from inside
fireplace for servicing as follows:
1. Remove glass doors (if equipped). See
Optional Glass Doors, on page 8.
2. Remove screens, grate, hearth pan brack-
ets and brick liners. See Figure 31 and
instructions under Optional Brick Liners,
page 9.
3. Remove 4 Phillips screws holding hearth
pan to fireplace and 2 screws located at
lower frame rail (see Figure 32).
4. Lift rear ends of hearth pan up until front
edge clears lower frame rail then slide
up on end and angle out of fireplace
opening.
5. Remove 4 Phillips screws holding face
extensions at top refractory clips (see
Figure 32).
6. Remove viewing screen from cabinet
face. Viewing screen is attached by mag-
nets (see Figure 33).
Note: Do not scratch viewing screen. Place
on a nonabrasive surface away from work
area. When replacing viewing screen painted
side must face inside of cabinet with pattern
facing up.
MAINTENANCE
Continued
Figure 31 - Accessing Imaging Unit
Refractory.
Brackets
Grate
Hearth Pan
Bracket
Hearth Pan
Bracket
Brick Liner
Brick.
Liner
Figure 32 - Removing Hearth Pan and
Face Extensions (Extensions for E32
Series Only)
Hearth Pan
Face Extensions
Refractory Clip
Viewing Screen
Figure 33 - Removing Viewing Screen
7. Remove 4 Phillips screws on base cover
and lift cover off cabinet base. See Figure
34, page 19.
Note: Only E32 series models have face
extensions that require removal to access
imaging unit. Model E36 series has inner face
panels that also require removal to access
imaging unit.