Desa E36L - Manual (Page 8)

www.desatech.com 111076-01F 8
ACCESSORy INSTALLATION
FEATURES AND OPERATION
Continued
Figure 11 - Control Panel
Figure 12 - Installing/Removing Glass
Doors
Spring Clip
Depress Spring
Clip to Release
Pivot Pin
Remove Pivot Pin
From Bottom Face
While Sliding Door
Out of Upper Track
Pivot Pin
Fold Bifold Door
After Releasing
Spring Clip to
Slide Door Out of
Upper.Track
Figure 13 - Adjust Glass Door
Spring Clip
Partially
Opened
Door
Side Front
Face
LOW LOW
MAIN
POWER HI- OFF
FLAME SPEED
HI- OFF
FLAME BRIGHTNESS
HEATER
ON/OFF
Switch
Flame Brightness
Flame Speed
Heater Switch
OPTIONAL GLASS DOORS
Models E36L and E32L will accept bifold glass
doors that are fully operable or a fixed panel
door that limits access to fireplace, (see Ac-
cessories, page 25).
Installing Bifold Glass Doors
Follow these steps to install left and right
operable panels:
1. With handle down, completely fold panel
on its hinges.
2. With handle facing center of firebox open-
ing insert lower pivot pin on door panel
into hole in bottom outer edge of firebox
opening (see Figure 12).
3. Keep folded door tilted and slide upper two
pins into guide track below upper facial
edge of firebox opening.
4. Tilt glass assembly fully vertical until outer
pivot pin snaps into mounting hole in up-
per spring clip.
5. Once top and bottom pins are secured,
unfold door into closed position.
6. Repeat steps 1 through 5 for opposite
door assembly.
7. To adjust doors, slide partially open.
Using a Phillips screwdriver, loosen hold-
down screws on spring clips (see Figure
13).
8. Close both doors until evenly joined at
middle and note gap as measured to outer
edges of front face.
9. Reopen each door one at a time and
retighten the hold-down screw while pre-
serving noted gap at each edge.
10. Repeat process until both doors are even-
ly joined, spaced and working freely.