Comtech EF Data CDM-800 - Manual (Page 47)

CDM-800 Gateway Router Revision 1
Rear Panel Connections MN-CDM800
3–11
3.3.2 115V/230V Alternating Current (AC) Power Interface (Standard)
Figure 3-5. CDM-800 AC Power Interface
3.3.2.1 AC Operation – Applying Power
Figure 3-6. Applying AC Power to the CDM-800
To apply AC power to the CDM‐800:
• First, plug the provided AC power cord female end into the unit.
• Then, plug the AC power cord male end into the user‐supplied power source.
• Finally, switch the unit ON.
Feature Description
1 On / Off Switch
2 Press‐fit Fuse Holder
3 IEC Three‐prong Connector
AC Power Specifications
Input Power 40W maximum, 20W typical
Input Voltage
100V to 240V AC, +6%/‐10%, autosensing
(total absolute max. range is 90V to 254V AC)
Connector Type IEC
Fuse Protection
Line and neutral fusing
(2X) 20mm Slow‐blow type fuses:
T2.5A (2.5A) (115V or 230V AC operation without BUC)
T4.5A (4.5A) (115V or 230V AC operation with BUC)