Comtech EF Data MiniMAC Operation ManualOperation Manual Operation Manual - Manual (Page 149)

MiniMAC Rack Management System SDM-300 Modem Screens
Rev. 0 6–29
6.7.3.2 Demodulator Commands
The DEMODULATOR COMMANDS Screen allows the user to configure or change all
the demodulator parameters including:
•
Demodulator Frequency
•
Sweep Reacquisition
•
Rate Preset Assignment
•
BER Threshold
•
Rate Preset Selection
•
Demodulator Type
•
descrambler Enable
•
Decoder Type
•
Differential Decoder Enable
•
Spectrum Rotation
•
RF Loopback
•
Reed-Solomon Decoder
•
IF Loopback
•
RX 8PSK Data Ordering
•
Sweep Center Frequency
•
Reed-Solomon Interleave
•
Sweep Width Range
•
8PSK 2/3 IESS-310 Op.
Note: If a modem type does not support a particular command and the command is
transmitted, the MiniMAC will Acknowledge with a NO RESPONSE confirmation
message.