Comtech EF Data SDM-2020 - Manual (Page 77)

SDM-2020 Satellite Modulator Revision 7
Front Panel Operation MN/SDM2020M.IOM
5-35
DTE STATE
NORMAL
This display shows the DTE STATE selection of either NORMAL or INVERTED. Upon
entry, the current status of the mode type is displayed.
1 Press [ ↑] or [↓] to select an item.
2 Press <ENTER> to execute the change.
DCE STATE
NORMAL
This display shows the DCE STATE selection of either NORMAL or INVERTED. Upon
entry, the current status of the mode type is displayed.
1 Press [ ↑] or [↓] to select an item.
2 Press <ENTER> to execute the change.
5.6.8.5 FUNCTION SELECT:UTILITY:G.703
INTERFACE TYPE
G.703
This status-only item displays G.703 or UNKNOWN. No changes can be made from this
menu. Use [
↑] or [↓]to select an interface type and press <ENTER>.
INTRFC LOOP THRU
OFF
This display shows the Interface Loop Thru either in ON or OFF position. Upon entry, the
current status of the mode type is displayed.
1 Press [ ↑] or [↓] to select an item.
2 Press <ENTER> to execute the change.