Dataprobe iPIO-2 Operation Manual - Manual (Page 24)

iPIO-2816_v140120e iPIO-2, iPIO-8, iPIO-16 Users Guide Page 24
9. Telnet and CLI
The system supports the Telnet communications protocol for basic setup only.
Connect via Telnet client to the IP address of the iPIO. Enter the credentials as set.
Hello... connected to ipIO-X!
Connected to Telnet Session 1
User> admin
Password> *****
Telnet Factory Default
Port 23
Command Description Factory Default
get network Get network IP settings
ipIO-X> get network
MAC Address: 00:0D:AD:02:57:87
IP Mode: Static
IP Address: 10.10.10.62
Subnet: 255.255.255.0
Gateway: 10.10.10.7
DNS1: 0.0.0.0
DNS2: 0.0.0.0
Ok
ipIO-X>
Note: DNS not used in this version
get mac Displays the MAC address
set ipmode <static|dhcp> Sets the IP Mode
Static: The IP address is set manually
DHCP: The IP Address is set by DHCP Server static
set ipaddress
<xxx.xxx.xxx.xxx> Sets the IP Address in dotted decimal 192.168.1.254
set subnet
<xxx.xxx.xxx.xxx> Sets the subnet mask in dotted decimal 255.255.255.0
set gateway
<xxx.xxx.xxx.xxx> Sets the gateway in dotted decimal 0.0.0.0
set telnet port <xxxxxx> Sets the telnet port (0-65535) 23