Digi NS9210 - Manual (Page 39)

. . . . .
www.digiembedded.com 39
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S w i t c h e s a n d p u s h b u t t o n s
Reset control, S3
The reset pushbutton, S3, resets the module. On the module, RSTOUT# and
PWRGOOD are produced for peripherals. A pushbutton allows manual reset by
connecting RSTIN# to ground. The reset controller is located on the NS9210 Processor
Module.
Power switch, S2
The development board has an ON/OFF switch, S2. The power switch S2 can switch
both 9V-30V input power supply and 12V coming out of the PoE module. However, if
a power plug is connected in the DC power jack, the PoE module is disabled.
Power Switch, S2
Configuration switch, S4
Reset button
S3
Serial Port B
(MEI)
configuration
switch S1
Wake Up button
S8
User Button 1
S6
User Button 2
S7