DFI LR102-B18D/B18S - Manual (Page 36)

36
2
Hardware Installation
USB Ports
USB allows data exchange between your computer and a wide range of simulta-
neously accessible external Plug and Play peripherals.
The system board is equipped with 6 onboard USB 2.0/1.1 ports. The 10-pin con-
nector allows you to connect 2 additional USB 2.0/1.1 ports. The USB ports may
be mounted on a card-edge bracket. Install the card-edge bracket to an available
slot at the rear of the system chassis then insert the USB port cables to the con-
nector.
BIOS Setting
Configure the onboard USB in the Chipset menu (“South Bridge Configuration”
submenu) of the BIOS. Refer to chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your operating system to use the
USB device. Refer to your operating system’s manual or documentation for more
information.
USB 0
USB 1
USB 6-7
10
VCC -Data +Data GND K
ey
VCC
-Data
+Data
GND
N.
C.
9 1
2
USB 2-3
USB 4-5