DR Power 46 Lawn Mower Deck - Manual (Page 14)

10 DR 46" LAWN MOWER DECK Safety & Operating Instructions
3. Install the two 3/8" x 1-3/4" bolts and washers into the two holes on the wheel
support bracket and tighten with a 9/16" wrench (Figure 3).
4. Mount the four 5/16" lock nuts and washers on the deck studs (Figure 2) and finger
tighten them. Then finish tightening them with a 1/2" socket or wrench.
5. Remove the 1/4"-20 Bolt & Lock Nut from the wheel spindle and remove the top two
(2) spacers (one 1/4" and one 1/2"). Mount the wheel on the bracket, replace the two
(2) spacers on top of the spindle, and replace the 1/4"-20 Bolt & Lock Nut (Figure 4).
Note: Install the Lock Nut only until one or two bolt threads appear.
6. Repeat for the other wheel. The cutting height is about 2" with the spacers positioned
this way. By repositioning the spacers, you can change the cutting height in 1/4" and
1/2" increments. See “Adjusting the Cutting Height” on Page 20 for more information.
Note: There is a right and left wheel caster assembly. When you mount the wheels, the
caster spindle should be on the outside when the wheel points toward the deck
(Figure 4).
Figure 4
Caster Spindle
on Outside
2 Spacers
above,
4 Spacers
below
Bracket
1/4"-20 Bolt
& Lock Nut