DR Power 46 Lawn Mower Deck - Manual (Page 19)

DR 46" LAWN MOWER DECK Safety & Operating Instructions 15
Check the Tire Pressure
There should be 30-35 psi in each front Caster Wheel Tire.
Figure 17
Figure 18
12. Install the Clutch/Brake Spring (Figure 17). Engage the Blade Control Lever and measure the
length of the spring. It should measure 3-1/2" from end to end. If you need to adjust it,
lengthen or shorten the Blade Engagement Cable by loosening or tightening the nuts on the
cable on the right handlebar (Figure 18). After adjusting the cable, measure the spring again.
13. Install the black Pulley Cover and tighten the Knob.
NOTICE! Grease the Caster Wheel Spindles. In order to avoid a messy assembly, we
did not grease the Caster Wheel Spindles at the Factory. Before using your
new DR 46" LAWN MOWER DECK, please follow the instructions in the
Lubrication section in Chapter 5.