Removing and replacing the blades – DR Power 46 Lawn Mower Deck User Manual
Page 32
28
DR 46" LAWN MOWER DECK Safety & Operating Instructions
Removing and Replacing the Blades
Tools Needed:
■
5/8 " Wrench or Socket
■
Gloves, to handle the blade
■
2" x 4" board, to brace the blade (optional)
■
Torque Wrench (optional)
Tip: You may want to block the blade with a piece of wood between the blade and the
deck to hold it while turning the blade screw.
1. Remove the 7/16" Cap Screw and 2-1/4" Washer (Figure 28).
2. Remove
the
blade.
3. Repeat Steps 1 and 2 for the other two (2) blades.
4. Mount the new blade, blade washer and cap screw, in that order, and tighten
securely (Torque 30-40 ft-lbs.).
5. Repeat Step 4 for the other two (2) blades.
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire(s).
WARNING! Use caution when pushing or pulling the wrench next to the
blade. Wear gloves, if the wrench slips off the cap screw, you
may be seriously injured.
Figure 28