DR Power Walk-behind 13 - 17 HP (April 2005 - August 2005) - Manual (Page 16)

12 DR  ALL-TERRAIN  FIELD and BRUSH MOWER Safety & Operating Instructions
Figure 4
To Install the Brush Deck
1. Remove the black belt guard by unscrewing the black knob, lifting the cover and
pulling up and back to remove it. The belt is shipped wrapped around the pulley.
2. Slide the power unit shaft into the brush deck and install collar and pin (Figure 2).
3. Install the belt on the pulley and clutch (Figure 3) and route the belt per the label on
the spindle housing (Figure 4). The tension lever may have to be released and
secured into slot. (Figure 5).
4. Release the belt tensioner (Figure 5) onto the belt.
5. Replace the belt guard and secure in place with the black knob.
Figure 5
Figure 2
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire(s).
Install Collar and Pin
Belt Tension Lever
Install Belt
Figure 3