DR Power Walk-behind 13 - 17 HP (April 2005 - August 2005) User Manual
Page 30
Advertising
26
DR
ALL-TERRAIN
FIELD and BRUSH MOWER Safety & Operating Instructions
To Replace the Drive Belt
Tools Needed:
■
7/16" socket
■
1/2" wrench
■
9/16" wrench
■
Gloves
1. Drain the gas and oil.
2. Remove the blade belt following the instructions as outlined in the previous page.
3.
Remove the pin and collar (Figure 16), and then pull the power unit away from the
deck.
4. Tilt the power unit forward onto the attachment pin.
Figure 16
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire(s).
Remove Pin & Collar
Advertising
This manual is related to the following products: