DR Power Tow-Behind All Terrain - Manual (Page 19)

CONTACT US AT www.DRpower.com 19
Changing the Engine Oil
The Engine on your machine is not equipped with an Oil Drain Plug and will
require some disassembly to fully drain the Oil. There is however an Oil
Suction Pump available to make draining the Oil easier. Please visit our web
site at www.DRPower.com or call 1-800-DR-OWNER (376-9637) for assistance.
Tools and Supplies needed:

SAE 30 HD Oil (refer to your Engine Owner’s Manual for quantity required)
 Suitable container for used oil
 Rags

3/8" Wrench
Note: Drain the oil when the Engine is warm. Warm oil drains quickly and
completely.
1. Remove the Belt as described in the “Replacing the Drive Belt” section in
this Chapter.
2. Remove the six Flange Bolts that secure the Engine Mount to the Frame
using a 3/8" Wrench (Figure 34).
3. Make sure to securely tighten the Gas Fill Cap.
4. Remove the Oil Cap/Dipstick and position a suitable oil receptacle beside
the Oil Fill Tube.
5. Lift the Engine and mount up and then set it down into the Frame cavity
(Figure 35).
6. Tip the Engine and Mount to drain the oil out through the Oil Filler Tube.
7. Position the Engine Mount onto the Frame and secure with the six Flange
Bolts using a 3/8" Wrench (Figure 34).
8. Reinstall the Belt and covers as described in the “Replacing the Drive Belt”
section in this Chapter.
9. Refill the Engine with Oil as described in the “Adding Oil and Gasoline” section in Chapter 2.
Note: Be sure to use environmentally safe disposal procedures in the disposing of the used oil.
Approved
Container
Figure 34
Oil Cap/Dipstick
Fuel Fill Cap
Flange
Bolts
Engine
Mount
Inside Frame
for Support
Oil
Figure 35