DR Power Tow-Behind All Terrain - Manual (Page 8)

8 DR ® 7.25 ALL-TERRAIN TRIMMER/MOWER
2. Remove the Bolt, Flat washer and Locknut that is installed on the Pivot
Bracket using two 3/4" Wrenches (Figure 4).
3. Insert the Rod End of the Spring Assembly into the Pivot Bracket and secure
with a Bolt, Flat Washer and Locknut using two 3/4" Wrenches. Do not over
tighten.
4. Remove the Hitch Pin from the Caster Wheel and install the Shaft into the
Caster Bracket (Figure 5). Reinsert the Hitch Pin to secure the Caster.
Greasing the Wheels and Wheel Support
Tools needed:

Grease gun

Lithium grease

Clean cloth
1. Apply general-purpose lithium grease to the Wheel Bracket Grease Fitting
and the Caster Wheel Grease Fitting using a grease gun (Figure 6).
2. Apply general-purpose lithium grease to the Tracking Wheel Grease Fitting
using a grease gun (Figure 7).
Adding Oil and Gasoline
Note: Refer to the Engine Manufacturers Manual for more detailed Engine
information.
Tip: To avoid confusion, we recommend leaving the caps ON the Fuel and Oil
Fills until you are ready to pour either gasoline or oil into the correct Fill.
Note: You will need approximately 15 to 22 ounces of SAE 30 high detergent oil
depending on Engine type. Use only SAE 30 high detergent oil classified “For Service
SF, SG, SH, SJ” or higher. Do not use special additives. Other types of oil could
cause problems with the operation of your machine. Please refer to your Engine
Owner’s Manual for detailed information on oil quantity and cold temperature oil
specifications.
Bolt, Flat Washer
and Locknut
Figure 4
Rod End
Pivot Bracket

You must add oil before starting the engine. This machine is shipped
without oil. Traces of oil may be in the reservoir from factory testing, but
you must add oil before starting the engine. Fill the reservoir slowly,
checking the level frequently to avoid overfilling.

To get an accurate reading when checking the oil level:
- The machine should be on a level surface.
- The dipstick must be screwed down to ensure an accurate oil level
reading.
Caster Wheel
Figure 5
Spacers
Hitch Pin
Figure 6
Caster Bracket
Grease Fitting
Caster Wheel
Grease Fitting
Tracking
Wheel
Grease
Fitting
Figure 7