DR Power Tow-Behind All Terrain - Manual (Page 7)

CONTACT US AT www.DRpower.com 7
Specifications
Engine 725 Series Briggs and Stratton. See your Engine owner’s manual for detailed Engine Specifications
Cutting Width 22"
Cutting Heights 3" to 6" in 1/2" increments
Cord Tip Speed (mph) 230
Cord Size 0.155" (Blue) or 0.175" (Green)
Offset Maximum Reach 45" nominally, 60" or 72" in offset position
Frame 11 Gauge Steel, Painted
Spindle Housing Cast Aluminum
Drive Belt 3L x 77", Aramid Reinforced
Cord Line Plates Cast Aluminum
Mow-Ball Heat, Impact, and UV-Resistant Polymer
Wheels 9" Diameter x 3.5" Wide
Hitch Type (pin/ball) 1/2" diameter clevis pin; 2" Ball Hitch Compatible w/ Additional Kit
Hitch Height 6" - 21" in 1.5" increments
Machine Dimensions 81" L x 60" W x 23" H
Machine Weight 262 lbs.
Ground Clearance 4" minimum
Tow Bar Length 40"
ASSEMBLY
Hardware Bag Parts (Figure 2 and Table Below)
Item Part no. Description QTY
1 ........ 34326 .......... Bolt, Hex, Flange, GR8, 3/8-16 x 3" LG .................... 2
2 ........ 16003 .......... Pin, Hitch Clip, 1/2" To 9/16", .12" Wire ................. 1
3 ........ 10179 .......... Washer, Flat, 1/2" ..................................................... 1
4 ........ 18737 .......... Pin, Clevis, 1/2" OD x 4.5" LG .................................. 1
5 ........ 18081 .......... Washer, Lock, 3/8" .................................................... 2
Compare the contents of the Hardware Bag with the list above and Figure 1. If
you have any questions please contact us at www.DRpower.com or call 1-800-
DR-OWNER (376-9637) for assistance.
Tools Needed:

9/16" Wrench
 3/4" Wrench
1. Position the Tow Bar Assembly onto the Pivot Assembly and secure with two
Flange Bolts and Lock Washers using a 9/16" Wrench (Figure 3).
5
Figure 2
3
2
1
4
Pivot Assembly
Figure 3
Tow Bar Assembly
Flange Bolts and
Lock Washers