Installing and removing the edger, Before installing the accessories – DR Power Power Take-Off (PTO) System User Manual
Page 12

Before Installing the Accessories
Each attachment has two slots in the axle that ends in a J feature. The shafts that install on the side of
the transmission marked with an R have a semi-circular notch in the end of the shaft by the slot. The
shafts that install on the side of the transmission marked with an L do not have this notch (Figure 6).
Figure 6
Notch
(4 places)
J-Shaped Slot
Right side attachment
J-Shaped Slot
No notches
Left side attachment
THE ACCESSORIES HAVE CAPS ON THE OUTSIDE ENDS: A RED CAP ON THE RIGHT AND A BLACK CAP
ON THE LEFT. BE SURE TO INSTALL THE RED-CAPPED END ON THE RIGHT SIDE OF THE
TRANSMISSION AND THE BLACK-CAPPED END ON THE LEFT SIDE OF THE TRANSMISSION.
INSTALLING THE ACCESSORY INCORRECTLY CAN CAUSE THE ATTACHMENT TO COME OFF DURING
OPERATION.
8 DR
®
TRIMMER/MOWER™ GEAR-DRIVEN POWER TAKE-OFF SYSTEM™