DR Power Tow-Behind 9.59 Premier (September 2014 - Present) - Manual (Page 25)

CONTACT US AT www.DRpower.com 25

Cut wet grass can be very heavy. Fill the Collector only 3/4 full if the
material is very wet. That will make the Leaf System easier to pull and
to dump.
Dumping
1. Shut down the Mower and Vacuum Engines and set the Mower Parking Brake
when you are at the Dump area.
2. Pull the Dump Lever to tip the Collector back (Figure 65). If the Collector
doesn’t tip back on its own you can lift up on the front of the Cart.
3. Lift up on the Tube Frame Handle to start emptying the Container and then
release (Figure 66). The Upper Collector will remain raised (Figure 67).
4. Drive the Mower forward with the Collector fully open to move the Leaf
System away from the pile of debris and allow all debris to slide from the Cart
Bed.
5. Pull down on the Tube Frame Handle to close the Enclosure onto the Cart.
Ensure that the Rear Flaps are positioned inside the Enclosure (Figure 67).
6. Pull down at the front of the Enclosure until the Latch is secured by the Dump
Lever (Figure 68).
7. Pull the Enclosure Sleeve around the Outlet Chute (Figure 69).
Rear Flaps
Figure 67

Always shut off the tractor engine and the vacuum engine and use caution
when dumping the collector load.

Never back up with the Cart in the dump position.
Dump
Lever
Figure 65
Unlock
Collector
Lock Collector
Latch
Tube Frame
Handle
Figure 66
Never drive in reverse with the Collector in the dump position.
Empty the Collector after each use. Do not store the Leaf System with debris
in the Collector.
Enclosure
Sleeve
Figure 69
Outlet
Chute
Dump
Lever
Pull Down Here
Figure 68