DR Power Tow-Behind 9.59 Premier (September 2014 - Present) - Manual (Page 27)

CONTACT US AT www.DRpower.com 27
8. Pull the Dump Lever out to raise the Cart Bed (Figure 75).
Note: The Gas Spring makes it easier to dump the loads in the Collector. The
Premier unit has one Gas Spring and can be left as is for Cart Mode. The
Pro and Pro XL use two Gas Springs and the left hand Spring should be
removed so closing the Cart is easier in Cart mode.
9. Pull out on one end of the left side Gas Spring to apply pressure (Figure 76).
Use a Flat Head Screwdriver to pry under the Retaining Clip just enough so
the Gas Spring end can be removed. Repeat for the other end of the Spring.
10. Leave the Cart tilted up for the next step.
11. Remove the two sets of Bolts and Locknuts from the Frame using two 3/4"
Wrenches (Figure 77).
12. If your machine has a Jack you should rotate the Handle to bring the Jack
Wheel up as high as it will go. This moves the Tow Hitch closer to the
ground to make disconnecting the Power Unit easier.
13. Block the Cart Wheels and have a helper pull on the Outlet Duct to take
pressure off the Pins when you perform the next step (Figure 78).
14. Remove the front (closest to the Hitch) Hitch Clip and Clevis Pin from the
Power Unit Frame (Figure 77).
15. Remove the rear Hitch Clip and Clevis Pin from the Power Unit Frame
16. Move the Hitch Pin, Rubber Washer, and Hitch Clip from the Power Unit
Hitch to the Pin Hole of the Cart frame to hitch the Cart to your Tractor.
17. Lift up on the Hitch to roll the Power Unit out of the way. Store the Power
Unit, Enclosure, Hose and Support in a protected dry area.
18. Push down at the front of the Cart until the Latch is secured by the Dump
Lever.
Figure 77
Clevis Pins and
Hitch Clips
Bolts and
Locknuts
Figure 78
Gas Spring
Figure 76
Screwdriver
Retaining Clip
Dump
Lever
Figure 75
Unlock
Cart
Lock Cart
Latch