DR Power RapidFire 3.0 HP DR (June 2014 - Present) Operating Manual - Manual (Page 12)

12 DR ® PREMIER RAPIDFIRE™ LOG SPLITTER
6. Remove the Gas Fill Cap and fill the Gas Tank with fresh, unleaded gas (with
a minimum of 85 Octane) to approximately 1" to 1-1/2" below the top of the
fill neck to allow for fuel expansion (Figure 13). Be careful not to overfill.
Install the Gas Fill Cap before starting the engine. See your Engine Owner’s
Manual for more detailed information.
NOTE: To refill the gas tank, turn the engine OFF and let the engine cool at least
five minutes before removing the gas fill cap.
Check the Tire Pressure
Tools Needed:

Tire Pressure Gauge

Air Compressor
1. Remove the Valve Stem Protective Cap (Figure 14) and check the tire
pressure with a Tire Pressure Gauge.
2. Check what the manufacturers recommended pressure is that is stamped on
the side of the Tire.
3. If the pressure is too low, add air through the Valve Stem with an air hose.
4. Replace the Valve Stem Protective Cap when finished.
Valve
Stem
Protective
Cap
Figure 14
Do not over inflate the tires. Inflate to the manufacturers recommended
pressure found on the tires.
We highly recommend the use of fuel treatments in your fuel to prevent
Carburetor fouling.
Gas Cap
Figure 13