DR Power 6.25 Premier Power Wagon - Manual (Page 24)

20 DR
®
POWERWAGON-PREMIER
Figure 12
Lubricate
Lubricate
Lubrication
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE, SET THE
PARKING BRAKE, WAIT FIVE (5) MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE SPARK
PLUG WIRE, KEEPING IT AWAY FROM THE SPARK PLUG.
Your DR POWERWAGON-PREMIER was lubricated at the Factory. The transmission is factory sealed
and lubricated for life with 16 ounces of 90-weight gear oil. The operator needs only to provide Engine
lubrication, wheel, and cable lubrication.
Supplies Needed:
•
SAE 30 Oil
•
#2 Lithium Grease
1. There are two (2) Grease Fittings on the Swivel Wheel,
one (1) at the top front of the Wheel Bracket, and one
(1) toward the center of the Wheel
(Figure 11). Grease
these two (2) fittings with #2 lithium grease to keep
the Wheel spinning freely, at least every 25 hours of
operation, per the Maintenance Checklist on page 18.
2. Using SAE 30 Oil, lubricate the Parking Brake Lever
Cable at the Operator's end and the Wheel Clutch
Lever Cable at both ends (Figures 12 and 13). Operate
the Levers to work the lubricant into the Cables.
3. Lubricate the Key Switch with SAE 30 Oil .
Figure 11
Grease
Fittings
Figure 13
Lubricate Cable