DR Power 5.00 HP Power Wagon - Manual (Page 29)

DR POWERWAGON 5.0 Safety & Operating Instructions 26
Figure 26
Figure 27
Replacing the Throttle Cable
Note: The Throttle Cable is set at the factory and generally no service is required. The
cable is supplied as a complete assembly with the handle already attached.
(Figure 27) However, when replacing the throttle cable it is important to follow
these steps:
Tools Needed:
1/4" socket
Screwdriver
1. Loosen the screw on the
throttle cable clamp with
the screwdriver so the
throttle cable can slide
below it. It is not
necessary to remove the
clamp. (Figure 26)
2. Remove the "Z"-bend end of the cable from the throttle plate. (Figure 26)
3. Remove the two screws holding the throttle assembly to the control panel with the
1/4" socket or screwdriver. (Figure 28)
4. Tilt and slide the throttle assembly down through the slot in the control panel.
(Figure 28)
WARNING! Before performing any maintenance procedure, stop the
engine, set the parking brake and disconnect the spark plug wire.
Throttle
Throttle Plate
Throttle Cable Clamp
Throttle Cable
"Z" bend
Figure 28
Throttle Assy
Screws
Slot