Flowserve FP - Manual (Page 36)

FP USER INSTRUCTIONS ENGLISH 71576286 - 02/13
Page 36 of 40
8.2.5 Parts list pumps 65 FP, 80 FP, 100 FP, 125
FP
N DESIGNATION N DESIGNATION
1130 Suction casing 4120 Gland
1140 Discharge casing 4130 Gland packing
1150 Stage casing 4132
Stuffing box neck
bush
1410 Diffuser 4590 Gasket
1470 Diffuser plate 4610
Round section joint
ring
1500 Casing wear ring 6515 Drain plug
2110 Pump shaft 6544 Circlip
2250 Impeller 6571 Tie bolt
2410 Interstage sleeve 6572 Stud
2450 Shaft sleeve 6577-01 Hexagon head bolt
2520 Loose collar 6577-02 Hexagon head bolt
2540 Thrower 6578 Threaded plug
2905 Washer 6581-01 Hexagon nut
2910 Shaft nut 6581-02 Hexagon nut
3011-01 Radial ball bearing 6581-03 Hexagon nut
3011-02 Radial ball bearing 6581-04 Hexagon nut
3134 Support foot 6700-01 Key
3200 Bearing housing 6700-02 Key
3260 Bearing cover 9331 Cover plate
3853 Grease nipple
8.3 General arrangement drawing
The typical general arrangement drawing and any
specific drawings required by the contract will be sent
to the Purchaser separately unless the contract
specifically calls for these to be included into the User
Instructions. If required, copies of other drawings
sent separately to the Purchaser should be obtained
from the Purchaser and retained with these User
Instructions.
9 CERTIFICATION
Certificates determined from the Contract
requirements are provided with these instructions
where applicable. Examples are certificates for CE
marking, ATEX marking etc. If required, copies of
other certificates sent separately to the Purchaser
should be obtained from the Purchaser for retention
with these User Instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS
10.1 Supplementary User Instructions
Supplementary instructions such as for a driver,
instrumentation, controller, seals, sealant system etc
are provided as separate documents in their original
format. If further copies of these are required they
should be obtained from the supplier for retention
with these User Instructions.
10.2 Change notes
If any changes, agreed with Flowserve Pump Division,
are made to the product after its supply, a record of the
details should be maintained with these User
Instructions.
10.3 Additional sources of information
Reference 1:
NPSH for Rotor dynamic Pumps: a reference guide,
Euro pump Guide No. 1, Euro pump & World Pumps,
Elsevier Science, United Kingdom, 1999.
Reference 2:
Pumping Manual, 9
th
edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom, 1995.
Reference 3:
Pump Handbook, 2
nd
edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.
Reference 4:
ANSI/HI 1.1-1.5, Centrifugal Pumps - Nomenclature,
Definitions, Application and Operation.
Reference 5:
ANSI B31.3 - Process Piping.