Flowserve MX Dashboard Limitorque - Manual (Page 6)

6
FCD LMENIM2338-01
To configure the MX/QX “port” setting, refer to the
LMEIM2306/3306 for detailed instructions.
To use the MX/QX Downloader option on the dashboard, the
MX/QX must be configured for IRDA in the “port” setup.
The ModSim option on the Dashboard is supported either
via IR or BT.
Setup example for the IR setting in the “port” menu:
Once the port is configured, Dashboard may be used to
communicate with the MX/QX via the user selected Local port.
Note: When using the IR option, line of sight is required with
the device. For best results hold the IR device approximately
12 cm or less, from the actuator. BT option supports a
maximum distance of 10 meters from the device.
Configuring the MX/QX BT option:
• In the ‘ports’ menu, select the BT port.
• Each BT-equipped MX/QX has a unique identifier. Note for
future reference.
• Configure the BT password. Default is “default123456789,” a
maximum of 16 alphanumeric characters.
• The user has the option to disable the password.
NOTE: Limitorque strongly recommends the use of a
non-default password on the MX/QX for security reasons.
• The MX/QX is now ready for use with the Limitorque
Dashboard application.
MX/QX configuration