Formax 6606 Series - Manual (Page 116)

An Example of OMR Code
In the figure the legend for the following example is shown. In this example, a set of 8
sheets with one selective feed and three sequence check marks is shown.
• The first position is used for the start mark which must be printed on every sheet.
• The second mark position is used for the insert/accumulate command. A printed
mark means insert, no mark means accumulate. Therefore the mark is printed on
the last sheet of the set.
• Position 3 is reserved for selective feed from the enclosure feeder. Print a mark on
position 3 when a selective feed from the enclosure feeder is required. The marks
are printed on the last sheet of the set.
• Position 4, 5 and 6 are used for the sequence check marks. In this case a three mark
sequence check is used.
Flex Reading Code Description
With "Flex reading" also non-standard codes and alternative document handling algorithms
can be recognized. Flex reading can be activated by a system specific license code and
by a customer specific setting that is saved in a physical dongle.
With Flex three types of reading can be supported:
• OMR
• BCR 1D
• BCR 2D
Depending on the license up to 9 Flex definitions can be used on the system.
Creating a Flex job is similar like creating a OMR / BCR reading job.
112
| Page 112 | feb-24-2014 01:32 | Reading
8
English