Formax Cut-True 27A - Manual (Page 10)

Programming a Divided Cut
Fig. 8b
Divided Cut
Total Paper Length
# of sections
7
Fig. 8a
Fig. 8c
Save Button
Save Icon
If all cuts on a sheet are the same length (i.e. no border or
full bleed and no gutter between cuts), simply program a
Divided Cut (Fig. 8).
1. Go to the Edit mode (Fig. 3) and select a job to be
programmed.
2. Press the enter button to access the first cut.
Press the back gauge block of cut 1 to set the first cut
(Fig. 4).
3. Enter the back gauge position for the first cut (Fig. 8a).
15” will be used for this example.
4. Press the Divided Cut icon and enter the total paper
length, and the # of sections and press the Save
button (Fig. 8b).
NOTE: The number must be divisible. For example,
15/5=3 and 10/4=2.50 are both divisible, but
14/6=2.333333333 is not divisible.
5. The measurements will be automatically calculated for
the job (Fig. 8c). Press the Save icon to
store the job.